Cambium Networks PTP 850E, Руководство пользователя

Страница: 337 / 560

Chapter 14: Radio Configuration (CLI) Configuring and Viewing Radio PMs and Statistics (CLI)
phn-3963_008v000
Page 14-7
Table 71 Excessive BER CLI Parameters
Parameter Input Type Permitted Values Description
admin Variable enable
disable Enables or disables propagation of excessive
BER as a fault.
threshold Variable 1e -3
1e -4
1e -5
The level above which an excessive BER alarm
is issued for errors detected over the radio
link.
The following command enables
excessive-ber
:
root> radio excessive-ber set admin enable
The following command sets the excessive BER threshold to 1e-5:
radio [2/1]>modem excessive-ber set threshold 1e-5
Configuring RSL Thresholds (CLI)
You can set two RSL (RX Signal Level) thresholds. The number of seconds during which the RSL exceeds these
thresholds are counted as RSL Exceed Threshold Seconds. See
Displaying RSL and TSL Levels (CLI) .
To set the RSL thresholds, enter the following command:
radio [x/x]>rf pm-rsl set threshold1 <threshold1> threshold2 <threshold2>
Table 72 RSL Thresholds CLI Parameters
Parameter Input Type Permitted Values Description
threshold1 Number -75 - -15 The first RSL threshold (dBm).
threshold2 Number -75 - -15 The second RSL threshold (dBm).
The following command sets the RSL thresholds to -30 dBm and -60 dBm, respectively.
radio [2/1]>rf pm-rsl set threshold1 -30 threshold2 -60
Configuring TSL Thresholds (CLI)
The number of seconds during which the TX Signal Level exceeds the TSL threshold are counted as TSL Exceed
Threshold Seconds. See
Displaying RSL and TSL Levels (CLI) .
To set the TSL threshold, enter the following command:
radio [x/x]>rf pm-tsl set threshold -15