Chapter 13: Getting Started (CLI)
Enabling ACM with Adaptive Transmit Power (CLI)
phn-3963_004v000
Page 13-196
Enabling ACM with Adaptive Transmit Power (CLI)
When planning ACM-based radio links, the radio planner attempts to apply the lowest transmit
power that will perform satisfactorily at the highest level of modulation. During fade conditions
requiring a modulation drop, most radio systems cannot increase transmit power to compensate
for the signal degradation, resulting in a deeper reduction in capacity. The PTP 820 is capable of
adjusting power on the fly, and optimizing the available capacity at every modulation point.
To enable Adaptive TX Power for a radio, enter the following command:
radio[x/x]>rf adaptive-power set admin enable
To disable Adaptive TX Power for a radio, enter the following command:
radio[x/x]>rf adaptive-power set admin disable
To display whether Adaptive TX Power is enabled, enter the following command:
radio[x/x]>rf adaptive-power show status
T
he output of this command is:
radio [x/x]>rf adaptive-power show status
RF adaptive power admin status: [enable/disable]
RF adaptive power operational status: [up/down]
RF adaptive power operational status:
Up
means the feature is enabled and fully functional for
that radio link. Note that the feature is configured and operates independently for each radio link.
