Cambium Networks PTP 820C, Руководство пользователя

Страница: 216 / 672

Chapter 6: Ethernet Services and Interfaces Configuring Ethernet Interfaces
phn-3963_004v000
Page 6-23
Figure 128 Physical Interfaces - Edit Page
3. Optionally, in the Description field, enter a description of the interface.
4. In the Media type field, select the physical interface layer 1 media type. Options are:
o
Auto-Type – NA.
o
RJ45 – An electrical (RJ-45) Ethernet interface.
o
SFP – An optical (SFP) Ethernet interface.
o
Radio – A radio interface.
5. In the Auto negotiation field, select On to enable or Off to disable Auto-Negotiation. When the
Media-Type is Radio, Auto Negotiation is always Off.
6. In the Speed field, select the maximum speed of the interface. Options are:
o
Ethernet RJ-45 interfaces – 100Mbps HD, 100Mbps FD, and 1000Mpbs FD.
o
Ethernet SFP interfaces – Only 1000FD is supported.
o
Radio interfaces – The parameter is read-only and set by the system to 1000FD.
1 In the Duplex field, select the interface's duplex setting (Full-Duplex or Half-Duplex).
Only Full-Duplex is available in this release.
2 Click Apply, then Close.
Table 34 describes the status parameters that appear in the Physical Interfaces page.
Table 34 Physical Interface Status Parameters
Parameter Definition
Interface location The location of the interface.
Operational Status Indicates whether the interface is currently operational (Up) or
non-operational (Down).