Cambium Networks PMP 450, Конфигурация и руководство пользователя

Страница: 144 / 196

Task 11: Configuring quality of
service Chapter 2: Configuration and alignment
2-112
pmp-0050 (May 2012)
Table 50 Where feature values are obtained for an SM with authentication required
Configuration
Source Setting
in the AP
Values are obtained from
MIR Values VLAN Values
High Priority Channel
State
CIR Values
Authentication
Server Authentication
Server
Authentication
Server Authentication Server Authentication Server
SM SM SM SM SM
Authentication
SM
Authentication
Server
Authentication
Server, then
SM
Authentication Server, then SM Authentication Server,
then SM
NOTES:
HPC represents the Hi Priority Channel (enable or disable).
Where Authentication Server , then SM is the indication, parameters for which Authentication Server does not send
values are obtained from the SM. This is the case where the Authentication Server server is operating on a
Authentication Server release that did not support the feature. This is also the case where the feature
enable/disable flag in Authentication Server is set to disabled. The values are those previously set or, if none ever
were, then the default values.
Where Authentication Server is the indication, values in the SM are disregarded.
Where SM is the indication, values that Authentication Server sends for the SM are disregarded.
The high-priority channel is unavailable to Series P7 and P8 SMs.
For any SM whose Authentication Mode parameter is not set to Authentication Required , the listed settings are
derived as shown:
Table 51 Where feature values are obtained for an SM with authentication disabled
Configuration
Source
Setting
in the AP Values are obtained from
MIR
Values VLAN
Values High Priority
Channel State
CIR Values
Authentication
Server AP AP AP AP
SM SM SM SM SM
Authentication
SM SM SM SM SM
For the case where the Configuration Source parameter in the AP is set to
Authentication Server
, the SM stores a
value for the Dynamic Learning VLAN parameter that differs from its factory default. When Prizm does not
send VLAN values (because VLAN Enable is set to No in Prizm), the SM
uses this stored Disable value for Dynamic Learning .
shows the following in the VLAN Configuration web page:
o
either Enable or Disable as the value of the Dynamic Learning parameter.
o
Allow Learning : No under Active Configuration .