CAMAG UV LAMP 4, Инструкция по эксплуатации

Страница: 6 / 13

Instruction Manual, November 2017 5
2 Unpacking/Installation
2.1 UV Lamp 4
The UV lamp should only be operated in combination with the UV Cabinet 4.
Attention
High UV intensities can be harmful. Do not operate the UV Lamp without
precautions. Avoid direct and indirect radiation especially to skin and eyes.
 Connect the UV lamp to a suitable power outlet with the supplied switching
power supply.
 The lamp is switched on/off with the corresponding (254/366) button.
 After 10 minutes, the timer automatically switches off the lamp
 The 10 minutes timer can be disabled by pressing the respective button for more
than 3 seconds.
(Button LED is blinking)
2.2 UV Cabinet for UV Lamp 4
The UV Cabinet is used for inspecting TLC plates under UV light in a bright environment.
A glass filter protects the eyes against UV light reflected during inspection through the
viewing window.
Attention
•
Your eyes are protected against reflected UV light by a glass filter in this setup.
Make sure to wear a face mask or protective goggles if you are not looking
through the viewing window with the UV lamp switched on.
•
Consider UV radiation intensities in chapter 0: Never work with unprotected skin
areas under UV light, e.g. for marking plates or adding texts!
 Place the UV Cabinet 4 on a suitable surface such as a laboratory bench with the
opening (shutter) towards the user.
 Remove the shipping protections at both sides of the UV filter (see Figure 1).