CAMAG ADC 2, Инструкция по эксплуатации

Страница: 19 / 41

ADC 2
Instruction Manual, November 2016 Page 18
5. Stand-Alone operation
The instrument can be used in Stand-Alone mode. Up to 10
methods can be stored and used locally. Further you can start 4
permanent programmed methods (S1 to S4).

Note that locally started methods cannot be used in an analysis
created in
visionCATS/winCATS, and that local parameter
changes are not documented in the software!
Procedure for Stand-Alone start:
 Prepare the instrument for development.
 Press the RUN key.
The most recently used method is displayed. With the

or

keys you can select another locally stored method.
 Press the
ENTER
key to start the displayed method. The last
method is re-started if ENTER is pressed in the “SYSTEM
READY” mode.
Procedure for local input of parameters:
 Press the
RUN
key.
The most recently used method is displayed. With the

or

key you can select another locally stored method.
 Press the
DIALOG
key to locally change parameters of the se-
lected method.
Press the

or

key to select a parameter group (global pa-
rameters, parameters or save method) for local input and press
ENTER to confirm.
 Now you can step through the parameters of the group by
means of the
ENTER
key or use the

or

key to change the
current parameter. To accelerate the change speed of a pa-
rameter you have to press the other arrow key a little bit later.
Press
ENTER
to confirm the new value and move on to the
next parameter.
Procedure for saving a changed method:
 Select the parameter group
Save method
or press the
END
key after having changed the parameters.
 Select the memory position to save the new method by means
of the

or

key. Press ENTER to confirm position and save
the parameters.