Calrec ARGO, Инструкция по установке и техническому обслуживанию

Страница: 69 / 92

69
WILD ASSIGN PANEL - CA6575
The CA6575 Wild Assign panels can
be fitted in the Argo S/Argo Q central
control area, for the Argo S, one row
of this panel type can be fitted and
for the larger Argo Q, two rows of this
panel type can be fitted to make up
the required console layout.
The CA6575 is 378.5mm wide x 190mm
high and is fitted with the following
controls/displays:-
PANEL CONNECTOR LAYOUT
CA6575 - ARGO S & ARGO Q WILD ASSIGN PANEL
48 rotary control cells arranged as 4 rows
of 12 sets of rotary control cells, with the
bottom row separated from the other 3
rows.
Each control cell contains a rotary shaft
encoder control with integral switch.
This is activated by pressing the top of
the encoder down this is typically used
to reset the parameter which the rotary
control is controlling.
It also contains a separate illuminating
button and a Mini TFT Display per cell.
Each rotary control cell can be configured
to display and control the various
continuous and switch parameters as
required.
Connections
This panel has two separate connectors for
power and control placed on the back of
the unit.
The Wild Assign panel connects to the
UN6539 section processor which provides
both power via a 4 pin 12v DC connector
and control data via a USB3 Type B
connector which uses the Superspeed
pairs to provide 2 x LVDS
outputs on each USB 3.0 port for
Mini-TFT data to the Control Surface
Modules. The USB 2.0 legacy pair in the
USB 3.0 connector transports surface
control events between panels and host
processor.