Calrec Argo S, Руководство для стартапов, Страница: 12 / 46

12 ImPulse
IP Audio Routing & Mixing System
Start Up Guide
5. POWER UP THE SURFACE & CREATE A NEW SHOW
FADER LAYOUT>NEW CHANNEL
Once the connections between the Impulse core and the Argo S or Argo Q console are made and the surface IP connections routed
to the surface application container in the core, the surface can be powered up. It is recommended that the Impulse cores are then
restarted. On restart, the console will boot up with the last loaded show To ensure you are starting from a clean setup, before
beginning configuration it is a good idea to create a new show
.
Shows contain default settings for the console, including monitor
patching, GPI patching & port labelling. Shows also contain multiple user memories which save normal I/O patching, fader assignment
and path parameter settings. To create a new show, go to the
Show area highlighted (top left of the page shown below) and tap
on it. This opens the Shows page and at the bottom is a ‘
+New
’ button which when pressed allows the user to create a new show.
Choose the Calrec Default as the starting template, enter the details as prompted and click ‘
Create
’ to load the new, clean show onto
the console. See the image below . The same page allows changes to the show to be saved, as well as other shows to be loaded &
saved, please refer to ‘
Argo Operator Manual (926-313).pdf.
The image shown below is accessed from the
Fader Layout
page which can be used to place Audio paths on to faders. Here the
user has selected a fader position (Layer 1-Fader 1A) and is about to add their first new path. As can be seen from the New Path
dialogue box there are 1122 mono channels available. The user may then begin to configure the mixer with DSP paths, routing etc,
however we would recommend that the user completes the setup first. See ”
13. Navigate the Console & Perform System Tests”
on page 34
for further information on Console operation and/or please refer to the Argo Operator Manual (926-313).pdf.
The DSP pack used here
has
1122 channels.
Your
Impulse system’s DSP Pack
will be pre-installed to order
.
The Impulse Core has a
number of DSP Pack sizes
available, which can be
installed in the DSP Module
and each pack size can be
used in conjunction with any
Argo S or Argo Q surface.
The DSP Pack options
available are shown in a
detailed comparison table at
the end of this guide. See:-
“DSP Pack Comparison”
on page 38
SHOWS>NEW SHOW