8
TROUBLESHOOTING
Threaded Jar bottom leaking
Ensure that the rubber gasket is on top side of blade assembly
and that is tucked in all the way down against the metal surface.
Threaded Jar bottom leaking
Ensure that the threaded jar bottom is tight.
Threaded Jar bottom difficult to
remove
Use filler cap as a tool to hold the jar bottom for better grip while
unscrewing. The bottom of the filler cap will mesh with the
center of the jar bottom and act as handle.
Why doesn’t the blender turn on?
Ensure the blender is plugged into a powered outlet. Verify that
the blinking light is active after pushing the POWER button.
Pulse speed is low
Select desired manual speed setting before pushing pulse
button.
Blend N Go cup does not stay in place Make sure that the four tabs are aligned with the slots and
press down and counterclockwise for proper mounting. In case
of difficulty inserting try again after rotating 90 degrees before
inserting.
All lights blinking after consecutive
blending cycles with Blend N Go cup
Multi-Blend Error - Open jar and check contents. Wait 30 seconds
or unplug and plug in unit, then select blending cycle.
