The USBCNC-INT kit includes a mounting bezel that also acts as a drill jig. Once the installer
has identified where the display should be mounted, the mark the small hole in the center and
drill a hole the same size. Mount the plate, level and tighten to the cabinet.
Figure 1
Note the orientation of the bracket. The large hole should be on the left. Place the display on the
bracket to see how the display has the RJ11 jack that protrudes through the large hole.
With the bracket held in place with a bolt through the smaller center hole, level the bracket and
mark the larger hole on the bracket, this will need to punched or step drilled to this same size.
Now drill the four outer holes using the bracket as a drill jig.
Remove the bracket.
Step drill or punch out the larger diameter hole. The display’s RJ11jack connector will protrude
through this hole.
This is the smaller hole
in the center. Use this to
hold bracket in place
while drilling the outer
four mounting holes.