3
Number paper
Transparent
cover
Front
Side
Back
Charging pins
Power ON/OFF
Reset
Mode switch
(vibration/
vibration&buzzer)
Built-in battery
Paper slot
LED1
LED2
LED3
Pairing button
Operation instruction
Diagram of receiver
1. Connect the call button keypad to power, it executes the self-testing procedure. Then the number
display shows “0”.
2. Press and hold “Power” button for 3s on side of the receiver to power on, the receiver will vibrate
and sound 3 times, and then LED1 indicator flickers every 3s, the receiver enters standby status.
Plug the receiver to the charging slot, it vibrates and sounds 3 times and then the blue charging
LED on, the receiver enters charging status.
3. When client places an order, the service people give one receiver to him(her) and note down the
number.
4. While the order is ready, the service people press keypad to call the client (number), the
【
Power
】
Press and hold the button for 3sec to power on the receiver, press again to power off.
Short press the button to reset standby status while there is calling.
【
Pairing
】
Press and hold the button for 3sec to enter pairing status.
【
Mode
】
Change the prompt mode of the receiver. The upper position is vibration only; the lower
position is vibration and buzzer.
Button function
【
Keypad
】
Press button from 0 to 9 to select a number from 1 to 999,
then press “Call” button to send. If selected wrong number,
press “Backspace” to delete and select number again.
Charging LED
