(
2
)
Pair call button
Press
【
STUDY
】
button
twice then the first channel LED will be ON that
means the receiver enters pairing settings. Then press the call button, the
LED will flicker twice which means the pairing successfully, and the LED
indicator jumps to the second channel, then press another call button to
pair the second one... Like this, finish all the 48 channels pairing one by
one.
Note: if only want to pair some one channels, in the pairing settings, press
UP/DOWN button to select the channel and then press the call button to do
pairing.
(
3
)
Delete all the call buttons
In standby status, press
【
STUDY
】
button for 10 sec, up to it sounds
“Restore to default”, that means all the all buttons are deleted.
Note: This function would delete all the paired call buttons, please do it
carefully.
(
4
)
Change some one call button
For example, if change number 10 channel call button to new one, press
【
STUDY
】
button for 2 sec to enter the pairing settings, and press
【
UP/DOWN
】
button to select channel 10. Then press the new call
button, it will cover the old call button.
FAQ
Problems
Reasons
Solutions
While power on, the receiver host
has no response.
The power adaptor is broken.
Change the power adaptor.
The signal of some call button is
not enough.
The power of battery is low.
Change the battery.
Receiver host cannot receive some
call button of them.
These call button are deleted.
Pair the call button again to the
receiver host.
No voice prompt while power on
or calling.
The volume is lowest.
Adjust the volume louder.
4
Note: While it is working, please pull the antenna out for the best receiving
effect.
