Operation
33
P/N 113564 Rev. 2
Twister II Robot User’s Manual
Caliper Life Sciences, Inc.
Setting up a Storage Configuration (Continued)
9
Click the
OK
button. The Stack Storage software begins
compiling the storage configuration. The
Analyzing CLARA
window opens.
Figure 8. Analyzing CLARA Application Window
10
Once the Stack Storage software has analyzed the CLARA
application, the
Capacity Planning
window opens (see
). This window displays the number of racks in the
system and the maximum capacity of one rack for each material
in the method.
Figure 9. Capacity Planning Window
11
If necessary, edit the number in the
Racks
column to match the
rack numbers in the system. Make sure the rack numbers match
the rack numbers that were taught in the Robot software.
Options are: 1 -3, 1- 6, or 1- 9.
12
Verify the
Max Capacity
column shows the actual number of
materials that will fit in the rack when the rack is full (see
). The default displayed by the software in the Max
Capacity column is an estimate based on the specifications of
the material.
Make sure the specified number of materials
will fit in the rack without extending above the top of the
rack.
When using plates with lids (defined as two different materials
with different names but the same material type), count the
number of plates plus the number of lids. The total stack of
materials MUST be below the top of the rack.
