1.
Before connecting the power cord to the power center, please make sure that the AC power supply is turned
off.
2.
Align the two (2) pins of the cell power cord connector with the socket on the top of the power supply.
3.
Center and insert the connector. Turn the round socket nut until the connector is locked in place. The power
center is a dual voltage of 115V-230V, which will automatically switch without additional wiring.
LED Light Instructions
SuperChlor / Salinity
Short Press
Show the salinity.
Long Press
(Until the long press light become green)
Enter SuperChlor mode, long time press again to exit setup. SuperChlor mode will
auto-exit after 24 hours.
Generate
The light stably on means it is operating. The light off means it is something wrong.
Cold-Water
Warning: the water temperature lower than 10 or higher than 50 , the system is
shut down.
Salt
Good LED On:
Good salt. It shows salt salinity is within the working range of 2600PPM-4450PPM.
Inspect Salt Red On:
Salt Level below 2300 PPM or above 6000 PPM
Inspect Salt Red Flashing:
Salt Level 2300 PPM to 2800 PPM/4500 PPM to 6000 PPM
Cell
Good LED On
:
The cell is good and produces chlorine gas.
Inspect Cell Red:
The cell needs to be inspected. This could mean the blades may contain calcium or the cell is not producing chlorine
gas.
Flow:
Good Flow LED On:
Enough water flows to produce chlorine gas.
No Flow LED Flashing:
There is water flow. Continuous detection of water for one minute is necessary when the system starts. Or the flow
of water is unstable.