EN-
To reverse gear control switch
To Hand brake switch
LINE OUT
LINE OUT
ANTENNA
CONNECTOR
FRONT
REAR
AUDIO OUT
CAMERA IN
VIDEO IN
VIDEO OUT 1
VIDEO OUT 2
FUSE 10A
L
R
L
R
L
R
ISO CONNECTOR
B
A
1
2
3
4
5
6
7
8
4
5 7
8
R
FRO
RE
CAMERA IN
VIDEO IN
L
L
To rear camera video out
10
7
1
2
3
4
4
4
5
5
6
6
8
9
1. UNIT
. RELEASE CASE
. DASH BOARD
4. HEX NUT
5. LOCK WASHER
6. PLAIN WASHER
7. CAR BODY
8. REAR SUPPORT STRAP
9. TAPPING SCREW
10. M5 X 15 HEX BOLT
Dashboard
WIRE CONNECTION
IN / OUT CONNECTOR
Audio Out: White (L) Red (R)
Connect this wire to rear seat A/V monitor system
Line Out (Front): White (L) Red (R)
Line Out (Rear): White (L) Red (R)
External Bluetooth Microphone
CONTROL WIRE
Parking (Gray) :
Connect this wire to car hand brake system
Tel mute (Black) :
Connect to mobile phone unit
When receiving calls, audio sound will be muted.
Rear camera (Red) :
Connect to back rear camera
During back gear condition, this wire should be connected to high voltage.
DRIVING WITHOUT VIDEO DISPLAY
Follow the installation below so when the car is in motion, no video will come out from the LCD screen.
Only sound can be heard from speaker.
Note:
- Only sound can be heard when car is in motion.
- Refer and follow your country’s law regarding driving with video.
Caution:
- Do not attempt to install it by yourself if the instruction is not clear to you. Consult you dealer concerning
the installation procedures.
TO SUPPORT THE UNIT
2 Video Outputs: Yellow
Connect to external A/V system to display
Video In: Yellow
Connect to external Video equipment
Rear camera In: Blue
Connect to rear camera output
Steps:
1. Connect the gray wire to the hand brake system.
. Check your hand brake switch and make sure it is connected to
car body chassis and properly grounded.
Содержание RMD 310BT
Страница 1: ......
