Trouble shooting
Symptom
Cause
Solution
No power
The car ignition switch have
not turn on.
If the power supply is connected to
the car accessory circuits, but the
engine is not moving, switch the
ignition key to “ACC”.
The fuse has been blown.
Replace a new one.
Presence of CD disc inside
the player.
Remove the disc from the player,
and insert a new one.
Disc can not be loaded
or ejected.
Inserting the disc in reverse
direction.
Insert the CD with the lab l facing
upward.
e
The surface of CD is extremely
dirty or has been scraped.
Clean the disc or try to replace
a new one.
Temperature inside the car
is too high.
Cool off or until the ambient
temperature return to normal.
Condensation
Leave the player off for an hour or so,
and then try again.
No sound
Volume is in minimum
.
Adjust volume to a desired level
.
The wiring is not properly
connected
.
Check wiring connection
.
Sound skips
The installation angle is
more than 30 .
0
Adjust the installation angle
less than 30
0
.
The surface of CD is extremely
dirty or has been scraped.
Clean the disc or try to replace
a new one.
The operation keys
do not work
1. The built-in microcomputer
is not operating properly due to noise.
2. The front panel has not
properly installed.
1. Press the RESET button
to restore the program.
2. Fixed the front panel into
its place.
No radio reception.
The antenna cable is not connected.
Insert the antenna cable firmly into
the antenna socket of this CD player.
In automatic search mode
the radio does not stop at
a transmitting station.
The transmission signals are
too weak.
Select a radio station manually.
The following chart will help in solving most problems that may occur. If you still have questions
after going through the checklist, please consult your local customer service representative.
Before going through this check list, refer the wiring and operating procedures.
17
