10
OPERATING THE SPEAKER IN AUX-IN MODE
1. Press the
button to turn on the unit.
2. Connect an audio cable to the headphone or line-out jack of an audio
device and plug the other end into the Aux -in jack located on back of
the main unit, it will access to AUX-IN mode automatically, the Pilot
lamp changes to Green color
3. Turn audio device on and play this device.
4. Press the + / - button on the speaker or
▲
/ on the remote to
raise/lower the volume level, When finished, press the
button to
turn off the main unit. Remember to turn off the speakers and your
audio device, too.
Notes:
1). If you're connected to the Line out Jack of your external device, then you
only need to adjust the volume control of this speaker. If you're connected
to the Headphone Jack of your external device, then you may need to
adjust both the volume control of your external device and the volume
control of this unit to find the most desirable volume setting.
TROUBLESHOOTING GUIDE
Should you experience difficulties in the use of this player, please refer to
the following chart.
Fault Cause
Solution
Unit cannot be
operated.
Unit crashes and
“hangs”
Disconnect from the mains for around 5
seconds. Then switch the unit on again.
No audio signal
via the Bluetooth
connection
Speaker is not paired
to the audio source.
Check whether a connection exists. If
necessary, pair the speaker again to the
audio source.
Volume too low
Increase the volume on the speaker
Increase the volume on the the audio
source.