Page 2 of 2
2020.5.11 Rev 0
SOLDERING &
CONNECTORS
This document is issued in strict confidence on condition that it
is not used as a basis for manufacture or sale and is not copied,
reprinted, or disclosed to a third party either wholly or in part
without the prior written consent of California Accent Lighting, Inc.
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
lip
LEDs
™
Specification Grade
Terminal Connector
Connected Boards
No gap between boards
Terminals
Power Connector or
Continuous Connector
Installed connector
1.
Insert terminal connectors into each terminal where two LED boards will be joined.
Push boards together leaving no gap.
Note:
and - terminals are aligned throughout the entire run.
1.
Insert power connector or continuous connector lead wires into LED board terminals.
Insert the positive wire (red) into the terminal marked “+”. Insert the neutral wire (white)
into the terminal marked “-”.
Note:
and - terminals are aligned throughout the entire run.
CONTINUOUS RUNS
CONNECTORS
LLED
8200-PC
Power Connector
Connect to power source
Make connections
3.
Perform continuity test before connecting fixture to power source.
Link:
http://www.calilighting.com/assets/pdf/lipleds/LLED8200-Continuity-Test.pdf
2.
Make connections between connectors.
Power Connector (20/2 Gauge Wire)
LLED8200-PC (33” Standard)
LLED8200-PC-X (X = Specify Length)
X”
1.5”
Power Connector Black (20/2 Gauge Wire with Black Jacket)
LLED8200-PC-BK (33” Standard)
LLED8200-PC-BK-X (X = Specify Length)
X”
1.5”
Power Connector White (20/2 Gauge Wire with White Jacket)
LLED8200-PC-WH (33” Standard)
LLED8200-PC-WH-X (X = Specify Length)
1.5”
X”