CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
1 / 29 / 2021 / Rev 2
Page 7 of 16
ALS
500T-RMW-TB
INSTALLATION INSTRUCTIONS
Mounting (Aircraft Cable Assembly) 1 of 3
Ceiling Line
~5-1/8”
Aircraft Cable
Mounting Surface
Excess cable
Cable Gripper
Aircraft Cable
Cable Gripper
Flat Bracket
Alignment Block
Hex Nut
Screw
7-5/16”
5/8” Drywall
T-Bar
Support Wire
Wall Stud
Maintain
Continuous Edge
Ceiling Line
Mount Wall Trim
Ceiling Line
Top of drywall
Do not install ceiling tiles until after installation of luminaires is complete.
The installation area must have at least 10” of overhead space.
1
Determine number of Aircraft Cable Assemblies required.
Note:
Refer to the diagrams on page 11 as a guide.
5
Install T-Bar ceiling grid. Assemble the grid so there is a continuous edge
around grid for the Ceiling Trim to rest on. Hang the center of the T-Bar 7-5/16”
away from wall stud.
2
Hang or cut drywall along installation area so it is flush with ceiling line.
Note:
Drywallers must hang drywall to the specifications. Only cut if necessary.
3
Mark locations along Wall Trim extrusion where it will be mounted to wall studs,
then drill holes as needed and mount to wall studs.
Note:
Mount Wall Trim extrusion using at least 1 screw per 2’, rounded up.
4
If applicable, assemble Aircraft Cable Assemblies. Use provided hardware to
secure Alignment Blocks and Cable Gripper to Flat Bracket.
6
Determine locations where Aircraft Cables will be mounted overhead. Secure to a
sturdy surface, such as studs, using hardware (by others) that is rated for the
weight of the luminaire. Ensure each luminaire is appropriately balanced.
Note:
Do not hang luminaire from weak material such as drywall or plywood.
7
Secure Aircraft Cable Assemblies to mounting surface. The top of the assembly
should rest approximately 5-1/8” above ceiling line. Adjust position of assembly
along aircraft cable using cable gripper. Do not trim excess cable at this time.
8
