Calford NCT688, Инструкция по эксплуатации

Страница: 5 / 12

To turn on the intercom, rotate VOLUME !
clockwise until it clicks. The CHANNEL
LED lights. Set VOLUME to mid-range.
Set CHANNEL and CALLING for each
station to the appropriate channel, as follows:
* If you want all the stations to communicate
with each other at the same time. set all
stations to the same channel.
* If you want to set up separate communica
tion systems, set each station to a di
ᚎ
erent
channel.
Follow these steps to prepare the stations for use.
Operation
station.
Talking
B) The intercom will release the lock automatically
(The talk indicator goes out) after 10 hours
monitoring.
5
SLIDE CHANNEL button to the channel of
!
the station you are calling.
If you are in the Kitchen (CHANNEL 3), and
!
wish to call the barn (CHANNEL 2). !
Slide Button to channel 2 .
Press CALL. The talk indicator lights. Each
!
station set to the selected channel sounds
!
a tone.
Press and hold down TALK. The talk indicator
lights. Speak in a normal voice.
Then, release TALK when you nish speaking
and listen for the response.
One minute after you stopped conversation, !
the kitchen unit channel ( with CHANNEL 2
LED lights - ON during your talking with
CHANNEL 2) will automatically shift back
!
to
CHANNEL 3 (This is kitchen designated !
channel) as stand-by mode.
Follow these steps to call / talk to another
Calling
You may add additional stations to the system.
Any intercom that transmits on the same
frequencies is compatible.
Using additional stations
When you hear a call tone or a caller's voice,
adjust VOLUME to a comfortable listening level.
Listening
Pressing LOCK has the same e
ᚎ
ect as holding
down TALK. Use LOCK to set the intercom
for monitoring another station's location
(such as a nursery or playroom), or when other
one-way communication is needed.
Monitoring
IMPORTANT NOTE:
1)
2)
Note:
Note:
ONLY ONE PARTY CAN TALK ON ONE
CHANNEL AT A TIME. -
Follow these instructions to monitor another
location.
A) You cannot call or talk to the locked station
while LOCK is on. Remember to release the
lock when you nish monitoring.
C) No LOCK function for “A” position. When you
press LOCK key, you will hear a beep
remind you that no LOCK function. If you
'to monitor a room, please slide to “B” or “C” position.
To release the lock, press TALK on the
The following suggestions will help you care for
your FM Wireless intercom so you can enjoy it
for years.
CAUTIONS
Keep the station dry, If the station gets wet,
wipe them dry immediately. Liquids might
contain minerals that can corrode the
electronic circuits.
Use and store the stations only in a normal
temperature environments. Temperature
extremes can shorten the life of electronic
devices, damage batteries, and distortor melt
plastic parts.
Handle the stations gently and carefully.
Dropping them can damage the circuit boards
and can cause the stations to work
improperly.
Keep the stations away from dust and dirt,
which can cause premature wear of parts.
1. Press LOCK on the station in the area you
want to monitor. The talk indicator lights.
monitored station, The talk indicator goes out.
2. Listen from your station.
3.
tone to
need