INSTALLATION AND STARTUP
A. Valve
a. Separate actuator from valve body by
pulling cotter pin.
b. If ordered (separately), install check valves
on hot and cold inlets of valve body (not
shown).
c. Install mixed outlet fitting (with gauge
holder) to valve body.
d. Install tail pieces to valve body.
e. Install valve into piping; do not install upside
down (actuator below piping).
f. Re-attach actuator to valve body.
g. Install mixed outlet temperature sensor and
temperature gauge into mixed outlet fitting.
h. Install strap-on recirculation return
temperature sensor (see instructions).
B. User interface/controller
a. Surface mount the DIN rail segment (supplied
with hardware).
b. On back of enclosure, open 3 clips, install on
DIN rail and snap close the clips.
a.
b.
2
