CHARGING THE BATTERY
The Chronograph has a built-in Lithium-Ion rechargeable battery. Battery life can depend on many factors so run times are approximate. This
battery will power the chronograph for approximately 12 hours under normal conditions, and for 2.0 hours when the lights are used.
To charge the battery, follow these steps:
1. Plug in the included USB wall adapter.
2. Connect the chronograph by plugging the provided USB-Micro USB cord into the
Chronograph housing
3. Connect the provided cord into the wall adapter.
NOTE:
A GREEN LED light near the charging port will flash when the battery is charging, and
will stay on steadily once it is fully charged.
The battery will take approximately 2.5 hours to fully charge.
NOTE:
Make sure to use the correct prongs on your wall mount. Below are instructions on how to switch out your prongs.
OPERATION
1. Place Chronograph on the tripod or a stable surface at the
appropriate height for firing projectile through the shooting
window. Be sure the LCD screen is facing towards the shooter.
2. Position the unit 10 to 15 feet (3-5m) in front of the muzzle
of a firearm or if using with a bow, at least one full arrow length
in front
3. Align the Chronograph:
a. Height, so that the projectile travels through
the center of the shooting window
b. Tilt Angle, so projectile travels parallel to the
top surface of the housing
c. Left/Right, so that projectile is in line with housing
4. Turn the unit on by pressing the button on top of the unit
5. Select the units by pressing the “Unit” button.
The selected unit will flash on the LCD screen
6. If lights are needed, press the to turn them on.
NOTE:
The lights use batter power quickly. Only use
them when shooting indoors or in low light conditions
such as sunrise and sunset.
NOTE:
For continuous use, the Chronograph can be powered
directly by the USB cord. This allows the lights to be used for
extended times.
UNIT
Power
Lights
On the underside of the wall charger
plug is a button. Push it to release the
Prong plate from the charger.
Slide the prong plate up out
of the wall mount.
Then slide the other prong
plate down into the wall
mount until it “CLICKS”
into place.
CAUTION:
Make sure the prong plate is fully seated into the wall
mount BEFORE plugging it into the outlet.
