CalDigit HDPro, Руководство пользователя

Страница: 11 / 36

10
10
Connecting the HDPro
The HDPro RAID contains 8 configurable hard drives. After installing the drive trays, connect the HDPro to the PCI-
Express / PCI-X card on your computer via the PCI-e cable.
1. Attach the HDPro to the PCI-Express card’s PCI-e port with the PCI-e cable.
2. Connect the HDPro to the AC power outlets & press the power switch of the HDPro. (Front of unit)
3. Wait approximately 20 seconds & then move on to
Power HDPro ON/OFF for the next steps.
Power HDPro ON/OFF
Power ON: Always turn on the HDPro first, wait 20 seconds, and then power up your computer.
Power OFF: Always turn off the computer first and then turn off the HDPro.
Please be careful around the power supply. Accidental contact with internal parts while
the power supply is powered on could lead to electrical shock.
Note : RAID controller is already installed within the
HDPro unit. If you recently upgraded controller card
memory; please read through these steps.
1. Attach the RAID Controller to the
included chassis using the included
screws.
2. Slide the Controller into the RAID
chassis.
3. Connect one end of the supplied cable
into the rear of the controller and the
other end to the connector Card. See
below.
Push
Attaching
Push each end of the cable into the
Redrive Card and the controller. Make sure
that it
clicks into place.
Removing
Using a finger pull the green tab to unclip
the cable.