9/27/2017
LMU-3640 Hardware & Installation Guide - PULS Wiki
https://puls.calamp.com/wiki/LMU-3640_Hardware_%26_Installation_Guide
11/23
Status Color
GPS Green
Comm Orange
WiFi/BT Blue
4
Configuration and Activation
This section details how to quickly get an LMU-3640™ provisioned and configured to point at a specific server. It is assumed that a PEG script has
already been created and is being managed through LMU Manager or PULS™, the CalAmp Maintenance System.
We are making three assumptions to simplify the setup process:
You have created, installed and configured an LM Direct™ Server to receive messages from the LMU-3640™. (See LM Direct™
Reference Guide for details)
You are using the standard wiring harness from CalAmp and the serial port expansion harness.
You have created a HyperTerminal or Putty session.
You have contacted the CalAmp sales team regarding the network availability of the LMU-3640™.
This device may not be supported
for all the carriers or networks listed in this section (CDMA-Verizon, CDMA-Sprint, HSPA, GSM), for product availability consult the
CalAmp sales team.
4.1
Quick Start - General Config
All LMU-3640™s must go through a common step during the configuration and provisioning process. Specifically, this is pointing the LMU to
your LM Direct™ server, either via IP or a URL.
This configuration process is accomplished via a series of AT Commands:
1.
Power up the LMU-3640™ and connect a serial cable from the LMU to your laptop
2.
Open a terminal session to the LMU-3640™
3.
Enter the address of the LM Direct™ server:
Where ddd.ddd.ddd.ddd is the publicly addressable IPV4 address of your LM Direct™ server and ppppp is the UDP port number.
4.
Alternatively if a URL has been set up for your LM Direct™ server, the LMU may be programmed with:
Where myURL.MyCompany.com is the URL assigned to the server.
5.
Enter ATIC to verify the correct settings are displayed for your Inbound Server.
This configuration process is accomplished via a series of SMS Commands:
1.
Power up the LMU-3640™ and your handset
2.
From the handset, send an SMS message to the LMU-3640™ phone number:
Where ddd.ddd.ddd.ddd is the publicly addressable IPV4 address of your LM Direct™ server and ppppp is the UDP port number
3.
Alternatively if a URL has been set up for your LM Direct™ server, the LMU may be programmed with:
AT$APP PARAM 2319,0,ddd.ddd.ddd.ddd
AT$APP PARAM 768,0,ddd.ddd.ddd.ddd
(32-bit products only)
AT$APP PARAM 769,0,ppppp
AT$APP PARAM 2319,0,myURL.MyCompany.Com