2015 Portable Spa
LTR20151001, Rev. A
W
ater Clarity
www.calspas.com
39
Spa Capacity
Amount of
BromiCharge™
Gallons
Liters
Pounds Kilograms
300
1135
3.6
1.6
400
1515
4.8
2.2
450
1700
5.4
2.5
500
1890
6
2.7
Use 1.2 lbs. per 100 gallons, or .5 kg per
378 liters.
The Cal Clarity II bromine generator automatically generates and releases free bromine into the spa water. You
will still need to test for bromine and occasionally adjust it to return the bromine level to the baseline.
Cal Clarity II Bromine Generator
Prior to filling a spa for the first time, or after
a routine draining, you will want to follow
this start-up plan to extend water life and
performance.
Fill the spa to the proper water level
1.
with normal tap water. (Do not use
soft water.) See page 12
for filling
instructions .
Turn on the spa and allow it to
2.
prime. See page 14 for priming
instructions .
Turn on the jets.
3.
Press the
4.
Boost button to turn on the Cal
Clarity II system. The red ON light should
appear steady. If it blinks, make sure the jets
are running.
Press and hold the
5.
Prog button for two seconds.
When the flashing number appears, press
the Prog button a second time. An animation
will appear, then a number showing the total
dissolved solids (TDS) level will be shown.
Add Bromicharge™ to the spa water. Use the
6.
table below to determine how much you should
use.
Let the spa run for 15 minutes. Leave it
7.
uncovered during this time.
Check the TDS level again (described in step 5).
8.
Set the Maintenance level. Press and hold the
9.
Prog
button for two seconds. A number will flash
showing the Maintenance Mode bromine level.
Press the UP or DOWN buttons to raise or lower
it. Press the Boost button to return Maintenance
Mode.
Use the table below to determine which level to
start at.
Spa capacity
Maintenance level
Gallons
Liters
300 - 400
1135 - 1515
10
400 - 500
1515 - 1890
15
> 500
> 1890
20
Put cover on spa and let spa run for 24 hours to
10.
allow it to heat to desired temperature.
After 24 hours, check TDS level again (as described
11.
in step 5). TDS should be between 3 - 5 ppm. If it
is too low, raise it in increments of 5 (as described
in step 9).
Starting the Spa with Fresh Water
This applies to spa owners with the Cal Clarity II bromine generator ONLY.
Содержание Home Resort Z-524L
Страница 1: ...LTR20151001 Rev A 1 14 15...
