5/16 OR 8mm
HEX WRENCh
Both D.S. / DSHO shoes must be " handed" to
match door BEFORE mounting. see Fig. 1
For Left Hand doors: All shoes are shipped assembled
for left hand doors. Insert
5
16
" (8mm) Hex wrench into
arm stop and turn counter - clockwise to seat stop as
tightly as possible.
INSTALLATION & ADJUSTMENT INSTRUCTIONS
(LEFT HAND SHOWN - RIGHT HAND OPPOSITE)
REGULATION
The BA series closer has been regulated prior to shipment.
If adjustment are necessary, carefully follow instructions.
CLOSING SPEED: See Closer Control Diagram on page 1.
To adjust Main Speed, turn reg. screw clockwise to decrease
or counter-clockwise to increase. To adjust Latch Speed,
turn reg.screw clockwise to decrease or counter-clockwise to
increase. Reg.screw locations are shown at left and on label
BACKCHECK: is essential to proper operation of Cush-Stop.
Use enough backcheck to prevent arm from striking arm stop
with impact. To increase resistance. Turn reg. screw clockwise.
- DO NOT USE ABRUPT BACKCHECK! -
6. Attach cover: place cover insert into proper slots for
either R.H. or L.H. door. Place cover over closer and hold
against door while tightening cover screws firmly
BRACKET
ARM STOP
FILLER PLUG
CAUTION
IMPROPER INSTALLATION OR REGULATION
MAY RESULT IN PERSONAL INJURY OR
PROPERTY DAMAGE
FOLLOW ALL INSTRUCTION CAREFULLY.
FOR QUESTION CONTACT DEALER
OPTIONAL
DROP PLATE
REMOVABLE INSERTS
TO CONVERT TO OPPOSITE
HAND COVER
SELECTOR VALVE SCREW
SIZE ADJUST
BACKCHECK SCREW
MAIN ARM
ARM
SCREW
COVER
SCREW
MAIN SPEED
SCREW
LATCH SPEED
SCREW
30º APPROX.
RIGHT HAND ASSEMBLY SHOW
HANDING & ASSEMBLY OF D.S./ DSHO SHOE
For Right Hand doors: (see illustration) Push filler plug
out of shoe. Using a
5
16
" (8mm) Hex wrench, turn arm in
hole marked "R". Turn wrench counter-clockwise, seating
stop as tightly as possible. Insert filler plug into other hole.
1.
Adjust spring power to match door width as indicated
by chart on front page.
2. Select proper templating on opposite page, based on
degree on openning/dead stop. The closer and arm holes
must be located for same degree of openning/dead
stop. Drill and/ or tap mounting holes in door and
head jamb.
3. Attach complete arm to closer, as shown at left.
Arm will be at about a 30º angle to closer body.
Fasten with arm shaft screw. The arm will appear to
be in an incorrect position. This is to accommodate the
pre-load required for parallel arm mounted door
closer. See Fig.2.
4. Mount closer on door, using fasteners provided.
NOTE: arm will provide some resistance.
5. Swing door open about 45º. Mount shoe to frame stop
per proper templating on opposite page. Be sure to
install the "fifth" screw. If stop is not wide enough,
use spacer block provided.
BEFORE INSTALLING THE ARM - TURN BACKCHECK
SELECTOR VALVE
(on back of closer) ALL THE WAY IN.
CAUTION
DO NOT BACK VALVES OUT OF
CLOSER OR A LEAK WILL RESULT
DWG # DCG10
20
-
3
/3
-
APR
2022
