STEP 7: INSTALL & ADJUST BOTTOM ROD
The rod length can be adjusted by the thread of the rod, adjust the
correct length when door is in the opened position,by aiming the
rod to the hole of the part (Q)
o
I
rod connector
/
STEP 8: INSTALL LATCH COVERS & ROD GUIDE
( 1 ) Install latch covers and fix/tighten them with screws (A).
( 2) Put rod guide midway between head cover and latch. Then, fix & tighen rod
guide with screws (F).
(A*4)
(F*2)
STEP 9: TEST PUSH RAIL & THE DOGGING FUNCTION
1.
The latches should engage the strikes when the door is closed. If the door can be pushed to open
without depressing the push rail, please check the rod length and installation(see step 3)
2.
The latches should disengage from the strikes freely when the push rail is depressed or dogged down.
If not, please check the rod length/installation again (see step 3)
3.
When applying outside trims:
(1). No trims : Exit only, latch bolts are retracted just by the push rail inside.
(2). Entrance : latch bolts are retracted by trim outside after the trim unlocked.
(3). Storeroom : latch bolts are retracted by trim outside with key only.
(4). Passage : latch bolts are retracted by trim outside always open.
4.
Dogging:Use dogging hex key and turn clockwisely 90
°
when depressing push rail. Latch bolts will
remain retracted.
CAL-ROYAL PRODUCTS, INC. USA I VERSION 2022
7
(Q)
EDG-4043- 01/23 - 7 of 8
