Cal Flame BBQ843P, Руководство пользователя, Страница: 8 / 16

Page 6 2008 Barbecue Grill and Cart Owner’s Manual
LTR20081050, Rev. A
Installation / Assembly
Check the grill controls to ensure all control valves 3.
are in the full OFF position.
Turn on the main gas supply and check all connec
- 4.
tions for leaks using soapy water as described in the
leak testing procedure section.
Warning: If you see bubbles in the soapy solution at any
of the connections, turn off the gas supply and tighten
the connection. If tightening the connection does not
seal the leak, it may be necessary to replace the flex
hose.
Installing the Grill in a Barbecue
Island
You will need a second person to help you to avoid
damaging the grill or your barbecue island .
Before installing a grill in any island or cut out, make
sure that the opening is not bigger than the outside
frame of the grill unit. The grill should rest on the lip of
the frame.
Pay careful attention to the location of the gas line. It
should be routed away from sources of heat and should
make as few bends as possible.
Check to see if the gas line connection will be accessible
when grill is installed.
If the gas line connection is not easily accessible •
when the grill is installed, support the grill above
counter level and attach the gas line to the grill.
When the gas connection is made, slide the grill into
the cut out.
If the gas line connection is accessible when the grill
•
is installed, slide the grill into the cut out and then
attach the gas line.
Be very careful not to kink the gas line when lowering
the grill into the cut out.
Keep your fingers away from where the grill will be sup -
ported on counter. Your fingers could become trapped
and serious injury could occur.
Check to make sure the grill is level and is supported
around the entire outside edge. If the grill is not level or
is unstable, use non-combustible shims under the out-
side lip to stabilize it.
Perform the leak test procedure as described earlier in
this manual.