CAKEWALK sonar x3, Справочное руководство

Страница: 871 / 2094

871
ReWire
Software instruments
• You can use SONAR’s automation functions on both synth and MIDI tracks that the ReWire
application uses.
• Muting or soloing a synth track that a ReWire device uses automatically mutes or solos the MIDI
track that feeds that synth track. Muting or soloing a MIDI track that a ReWire device uses will
mute or solo the corresponding synth track only if there is only one MIDI track feeding that synth
track.
• You must always close your ReWire application(s) before you close SONAR. Some ReWire
applications prevent SONAR from closing properly if the ReWire applications are still open.
For step-by-step procedures, see:
“Inserting a ReWire instrument” on page 871
“To use separate synth tracks for each ReWire device” on page 873
“Automating ReWire instruments” on page 874
“Mixing down ReWire instruments” on page 874
“ReWire troubleshooting guide” on page 874
Inserting a ReWire instrument
After you install your ReWire applications and reboot your computer, the names of the ReWire
applications appear in SONAR’s
Insert menu under ReWire Devices, and also in the Synth Rack’s
Insert button pop-up menu.
To insert a ReWire instrument
1. Open a SONAR project. Do not launch your ReWire application.
2. In the Synth Rack, click the Insert button, and click ReWire Devices to display the submenu of
installed ReWire devices.
OR
Use the
Insert > ReWire Devices command to display the submenu of installed ReWire
devices.
3. Click the name of the ReWire device you want to insert.
The
Insert Soft Synth Options dialog box appears.
4. Choose options from the Insert Soft Synth Options dialog box according to the following:
• If you want to create a MIDI track that uses the ReWire Instrument as an output, check the
Create These Tracks: MIDI Source check box.
• If you want to create a single synth track that acts as an output for Output 1 of the ReWire
Instrument, check the Create These Tracks: First Synth Audio Output check box.
Note: ReWire supports both 32-bit and 64-bit programs, but it is not possible to mix the two
environments. A 32-bit program and a 64-bit program cannot communicate via ReWire. Make
sure you load the correct version of your ReWire device, depending on whether you are using
the 32-bit or 64-bit version of SONAR.