CAI Networks 690PG, Руководство по установке, Страница: 7 / 12

- 3 -
Section 1
Main Components
1.1 Front View
1.1.1 Toggle Power Switch
This switch toggles power on. To force power off, the switch must be pressed and held for 5
seconds. However, it is not recommended to use this power switch to shut down the unit.
Please use the LCD panel, web interface, or command line interface to issue a proper shut
down.
1.1.2 Reset Button
Reset the built-in switch only. Please refer Section 2 “swctl” shell command for details.
1.1.3 Up Arrow Button, Down Arrow Button
When each button is pressed, the value on the cursor location increases or decreases. It goes
through lower case letters, upper case letters, numbers and symbols. When the cursor is
located at the left most position on the LCD, the up and down arrow allows the user to select
a different item to setup.
1.1.4 Left Arrow Button and Right Arrow Button
When each button is pressed, the cursor moves to the left and right.
1.1.5 Check Mark Button, and Cross Button
Check Mark Button confirms the selection, Cross Button cancels the selection. At any time
when the system is running holding down to the Check Mark Button will invoke the
configuration menu, where you can change IP addresses and other settings.
1.1.6 Switch Ports
There are 20 gigabit Ethernet copper ports and four optical gigabit ports.
1.1.7 Console Port
Serial console port at 115200-N81 speed for shell commands and switch configuration.