At power-up, the letter
b
is displayed to indicate the phase of boot by the
microprocessor. Then, the reference of the firmware will be displayed to confirm the
correct function of the system implementation.
During power-up, the version of the software from Central appears a few seconds.
Once the complete boot sequence, the display turns off.
The plant is now operational and can be programmed: UHF channels, gain, etc.
IMPORTANT
:
To avoid any risk of deterioration of the central or other components
connected to the latter due to a too high output level, lower the gain to the minimum
settings: '30'.
2 / the frequency input UHF range programming
Press the
'OK'
button for 5 seconds: the display shows the selection of the frequency
range of UHF inputs.
Ex :
Press
'OK'
:
the display starts to Flash.
Press
'OK'
:
the display starts to Flash.
With touch
⋀
and
⋁
do scroll through the different configurations of the LTE filter; press
'OK'
to confirm your choice.
The LTE filter can be programmed to select the UHF frequency range
LtE.0 = 21... 69
LtE.4 = 21... 60
LtE.5 = 21... 48
3 / THE CONFIGURATION
Once the configuration of the LTE filter, you will enter the mode the configuration of
filters.
Press
'OK'
:
the display starts to Flash.
With touch
⋀
and
⋁
do scroll through the different configurations of filters; press
'OK'
to
confirm your choice.
Ex: Correlation table
Input
UHF1
UHF2
Filtres group
10
0
6
LtE.4
