Caffitaly System S18, Инструкция

Страница: 11 / 24

11
English
First use or after a long period of disuse
• Fill the tank with fresh, plain water (Fig. 4).
• Plug in the appliance and turn it on (Fig. 13).
• Make sure the lever is closed (Fig. 3).
• The buttons A - B - C blink together with alternate RED blinking of the indicator D .
• Place a large container (at least 250 ml) under the dispenser (Fig. 9).
• Press one of the buttons A - B - C. Wait for the machine to complete the water circuit fi lling
cycle. The indicator D goes off.
NB : If, after fi lling, the buttons A - B - C and the indicator D continue blinking, repeat
the operations of the previous point.
• Buttons A - B - C blink simultaneously; the machine is in the heating phase.
• When the buttons A - B - C light up steady, carry out the rinse by pressing the button C .
Press the button again to do another rinse. Wait for the machine to complete the rinse
cycle.
• At the end of this operation, empty the water from the used capsule drawer (Fig. 6).
Turning on the appliance
• Fill the tank with fresh, plain water (Fig. 4).
• Switch on the appliance by pressing the main switch (Fig. 14).
• Buttons A - B - C blink simultaneously; the machine is in the heating phase. When the
buttons light up steady and 2 beeps sound, the appliance is ready to use.
General operating indications
DESCALING SIGNAL:
• When the indicator D blinks YELLOW , and 3 beeps sound, it is advisable to carry out the
descaling cycle (See the section Descaling).
HEATING:
• Buttons A - B - C blink simultaneously.
WHEN THE WATER FINISHES DURING OPERATION:
• When the indicator D blinks RED , and 3 initial beeps sound followed by 1 intermittent, the
water tank is empty.
• Fill the water tank with fresh, plain water (Fig. 4).
• Press one of the buttons A - B - C . Wait for the machine to complete the water circuit fi lling
cycle.
• When buttons A - B - C light up steady, the appliance is ready to use.
IF THE LEVER IS RAISED WHILE DISPENSING:
• Raising the lever while dispensing a product (Fig. 1) may cause splashes of hot water.
Danger of scalding!
• The indicator D blinks RED and an intermittent beep sounds. The appliance will
immediately stop dispensing.
• Close the lever (Fig. 3).
• Press one of the buttons A - B - C to reset the alarm.
• The appliance is ready for use again.