Caen RFID Quattro R4321P, Техническое руководство

Страница: 41 / 70

EASY2READ PROFILE - Quattro Technical Information Manual 41
Connecting using the Ethernet port
Ethernet Communication Setup
The Quattro reader can be connected to a PC using an Ethernet cable. In order to correctly operate with
the reader follow the steps above:
1. Connect the antenna cable to Ant-0 (see § Fig. 3.6: Antennas page 16) of the reader.
2. Connect the Quattro to the power supply, the power LED will turn on, wait about 30 seconds until
you hear a beep, wait 10 seconds again and the reader is ready to work with the EASY2READ profile
active.
3. Plug an Ethernet cable
8
(not provided) into your computer and connect the other end of the
Ethernet cable to the reader. If your private network matches the default network configuration of
the reader (IP address 192.168.0.2) you can connect to it, otherwise you can:
a. change the network configuration of the reader (see § NETWORK page 19) to connect it to
your network
or
b. disconnect your PC from your network and connect it to the network of the reader.
Now you can use the CAEN RFID Easy Controller Application to control the reader.
8
For proper operation of the device:
- Ethernet cable shall be CAT6 at least (type S/FTP or S/STP)
- Put two ferrites (P.N. RRC-13-7-23-M-K5B by RICHCO; CAEN RFID ordering code LFAAFFP00004) on the Ethernet cable,
near the reader connector.