CAE BPDA230-AP, Руководство пользователя, Страница: 11 / 15

©2022 CAE 905K006452 v1.0 7
Using the Training Model
Using the Training Model
This section has information and instructions about the setup and use of the training model and any specific
training procedures.
Setup
Follow the guidelines below to unpack and set up your CAE Blue Phantom training model.
1. Open the shipping carton:
º
Use extreme caution with sharp tools, such as a box cutter, to avoid damage to the training
model.
2. Unpack the equipment:
º
Remove the training model from its shipping container. For heavier models, use proper
lifting techniques to prevent bodily injury.
º
Review the equipment, accessories, and supplies to make sure all necessary pieces are
present. See the Equipment Overview section of this guide for a list of items included with
this model.
3. Set up for training:
º
Put the model on a stable patient bed, stretcher, or table.
º
Prepare your ultrasound system and equipment.
º
Gather any procedural equipment and supplies.
Training
This section provides information about using your model for training and practice.
Ultrasound Scanning
Note: CAE Blue Phantom products do not teach ultrasound procedures or techniques. Refer to your
institution or training program for more information.
To scan with your training model and conduct a simulated ultrasound-guided procedure:
1. Place the model in the appropriate position for scanning.
2. Place ultrasound gel on the transducer or on the training model in an adequate quantity so that
the transducer slides effortlessly on the model. Add more gel as needed.
3. Adjust the ultrasound system controls per your training protocol and the manufacturer’s
instructions. Optimize the image with the ultrasound controls as needed.