CADO AP-C200, Инструкция по эксплуатации

Страница: 10 / 16

8
Changing the Air Volume
Press the air volume button ( ).
Air volume and operation mode cannot be configured simultaneously.
Each time the air volume button is pressed, it makes a beeping
sound and the air volume mode changes.
The indicator of the selected air volume will light up.
Operation continues with the selected air volume.
Selecting the Operation Time
Press the timer button ( ).
Each time the timer button is pressed, it makes a beeping
sound and the time setting changes.
The indicator of the selected timer will light up.
1h 4h 8h Off
The timer setting will be deactivated when the timer is off.
Turning off the Odor and Dust
Monitor
Press the light button ( ).
If the light button is pressed during operation, there will be a
beeping sound and the odor and dust monitor will turn off.
If the light button is pressed again, it will light up again.
Note
The inlet lamp will not turn off completely even after the light button is
pressed. This light is from the photocatalytic lamp that always lights
inside of the unit.
Deodorizing/Dust Collecting/Anti-Bacterial Filter
Remove the dust on the net surface of the filter. To take out the filter
from the unit, refer to “Replacing the Deodorizing/Dust Collecting/
Anti-Bacterial Filter” (
☞
page 10)
.
How to Operate
Starting the Unit
Plug the power plug into an wall outlet.
All indicators and buttons on the control panel along with
the odor and dust monitor will momentarily light up then turn
off.
Press the power button ( ).
After it beeps, all of the buttons on the control panel along
with the automatic indicator, and odor and dust monitor will
light up.
If the power button is pressed while the unit is still operating,
the lit buttons, indicators, and odor and dust monitor will turn off
then the unit will stop operating.
Selecting the Operation Mode
Press the mode button ( ).
The operation mode and air volume cannot be set simultaneously.
Each time the mode button is pressed, it makes a beeping
sound and the operation mode changes.
The indicator of the selected mode will light up.
About operation mode
Auto-
matic Normally use this mode.
The room condition is detected with the odor and dust
sensors, and the air volume setting switched between
low, middle, and high.
Eco Used in situations with low volumes of air pollutants,
such as at night.
Only the power button and eco-mode indicator light up
and the unit operates with low air volume setting. (The
photocatalytic lamp is also off.)
Rapid
Use this mode if you want to quickly clean the air.
The unit operates with an air volume stronger than the
high air volume setting for 2 hours, then changes to
automatic mode.
1
2
Power button
Mode
indicator Air volume
indicator
Rapid
Eco
Automatic
High
Middle
Low
Timer
indicator
Mode button
Air volume
button Timer
button
Light button
Illumination intensity
sensor
☞ page 5
Filter replacement indicator
☞ page 10