Cadillac XT4 Owner Manual (GMNA-Localizing-MidEast-13527545) - 2020 -
CRC - 9/16/19
262
VEHICLE CARE
If the tire is overinflated by more than
35 kPa (5 psi), the horn will sound
multiple times and the turn signal
lamp will continue to flash for several
seconds after filling stops. To release
and correct the pressure, while the
turn signal lamp is still flashing,
briefly press the center of the valve
stem. When the recommended
pressure is reached, the horn
sounds once.
If the turn signal lamp does not flash
within 15 seconds after starting to
inflate the tire, the tire fill alert has
not been activated or is not working.
If the hazard warning flashers are on,
the tire fill alert visual feedback will
not work properly.
The TPMS will not activate the tire fill
alert properly under the following
conditions:
.
There is interference from an
external device or transmitter.
.
The air pressure from the inflation
device is not sufficient to inflate
the tire.
.
There is a malfunction in
the TPMS.
.
There is a malfunction in the horn
or turn signal lamps.
.
The identification code of the
TPMS sensor is not registered to
the system.
.
The battery of the TPMS sensor
is low.
If the tire fill alert does not operate
due to TPMS interference, move the
vehicle about 1 m (3 ft) back or
forward and try again. If the tire fill
alert feature is not working, use a tire
pressure gauge.
TPMS Sensor Matching Process
Each TPMS sensor has a unique
identification code. The identification
code needs to be matched to a new
tire/wheel position after rotating the
vehicle
’
s tires or replacing one or more
of the TPMS sensors. The TPMS
sensor matching process should also
be performed after replacing a spare
tire with a road tire containing the
TPMS sensor. The malfunction light
and the DIC message should go off at
the next ignition cycle. The sensors
are matched to the tire/wheel
positions, using a TPMS relearn tool,
in the following order: driver side
front tire, passenger side front tire,
passenger side rear tire, and driver
side rear tire. See your dealer for
service or to purchase a relearn tool.
There are two minutes to match the
first tire/wheel position, and
five minutes overall to match all four
tire/wheel positions. If it takes longer,
the matching process stops and must
be restarted.
The TPMS sensor matching process is:
1. Set the parking brake.
2. Place the vehicle in Service
Mode. See
.
3. Make sure the Tire Pressure info
page option is turned on. The
info pages on the DIC can be
turned on and off through the
Options menu. See
Содержание XT4 2020
Страница 6: ...Cadillac XT4 Owner Manual GMNA Localizing MidEast 13527545 2020 CRC 9 16 19 6 INTRODUCTION 2 NOTES...
Страница 107: ...Cadillac XT4 Owner Manual GMNA Localizing MidEast 13527545 2020 CRC 9 16 19 INSTRUMENTS AND CONTROLS 107 Uplevel...
Страница 229: ...Cadillac XT4 Owner Manual GMNA Localizing MidEast 13527545 2020 CRC 9 16 19 VEHICLE CARE 229 Engine Compartment Overview...