13
Driver
Information
Safety &
Security
Comfort
Performance &
Maintenance
Owner
Privileges
TM
Entertainment
Convenience
Starting the Vehicle
To remote start the vehicle:
1. Aim the RKE transmitter at the
vehicle.
2. Press and release the
(Lock)
button on the transmitter.
3. Immediately press and hold the
(Remote Vehicle Start) button
for about four seconds.
4. When the vehicle starts, the
parking lamps will light and
remain on while the engine is
running.
5. Repeat these steps for a 10-minute
time extension.
When you enter the vehicle after a
remote start, the key must be
inserted in the ignition and turned to
the Run position before driving.
Canceling a Remote Start
If you wish to turn off the engine
instead of driving after a remote
start, perform one of the following
functions:
•
Press and hold the
button until
the parking lamps turn off.
•
Press and release the Hazard
Warning Flashers button inside the
vehicle. Press the button again to
turn off the flashers.
•
Turn the key in the ignition switch
on and then off.
•
The engine will automatically stop
when time expires.
AUTO TURN SIGNAL
The turn signal lever includes an
automatic lane change signal feature.
To signal a lane change, raise or
lower the lever until the arrow on the
instrument panel cluster starts to
flash, and then release the lever. The
turn signal will automatically flash
three times. If the Tow/Haul mode
is selected, the turn signal will
automatically flash six times.
To signal a turn, move the lever all
the way up or down.
INTELLIBEAM AUTOMATIC
HEADLAMPS (if equipped)
IntelliBeam uses a digital light sensor
behind the inside rearview mirror to
maximize forward night vision. The
system automatically switches on the
high-beam headlamps when no other
vehicle traffic is present, and switches
to low beam intensity when the
headlamps or taillamps of other
vehicles are detected. The system
operates only when driving over
20 mph.
The system is turned on
automatically when the headlamp
system is set to AUTO and the turn
signal/multifunction lever is in the
low beam position.
To turn off the system, press
and hold the
(Auto
Headlamps) button on the inside
rearview mirror for three seconds.
Press the button again to turn the
system back on.
Note:
The Remote Vehicle Start feature
will not operate if the key is in the
ignition, a door or the hood is open, or
the Check Engine light is illuminated on
the instrument panel cluster.
Escalade 2007 B 1/11/07 12:17 PM Page 15
