2-90
2. Press the Learn or Smart button on the garage
door opener motor head unit. An indicator light will
begin to flash when the motor head unit enters the
training mode.
Following this step, you have 30 seconds to
start Step 3.
3. Return to HomeLink in your vehicle and firmly
press and release the programmed HomeLink button
three times.
The rolling
-
code garage door opener should now
recognize HomeLink. You may either use HomeLink or
the hand
-
held transmitter to open the garage door.
If after following these instructions, you still have
problems training the garage door opener, contact the
manufacturer of HomeLink at 1
-
800
-
355
-
3515, or on
the internet at www.homelink.com.
Canadian Programming
Canadian Owners: During programming, the
hand
-
held transmitter may automatically stop
transmitting after two seconds. In this case, you should
press and hold the HomeLink button (see Steps 2 and 3
under “Programming the HomeLink Transmitter”)
while you press and re
-
press (cycle) your hand
-
held
transmitter every two seconds until HomeLink
is trained.
Содержание ESCALADE EXT 2002
