background image

SAVE THESE INSTRUCTIONS

IMPORTANT INSTRUCTIONS

2

TOOLS REQUIRED

1.  Read all instructions before 

installing or using this heater.

2.  This heater is hot when in use. 

To avoid burns, do not let bare 

skin touch hot surfaces. Keep 

combustible materials, such as 

furniture, pillows, bedding, pa-

pers, clothes, etc. and curtains at 

least 3 feet (0.9 meters) from the 

front of the heater and keep them 

away from the sides and rear.

3.  Extreme caution is necessary 

when any heater is used by or 

near children or invalids and 

whenever the heater is left oper-

ating and unattended.

4.  Do not operate any heater after it 

malfunctions. Disconnect power 

at service panel and have heater 

inspected by a reputable electri-

cian before reusing.

5.  Do not use outdoors.

6.  To disconnect heater, turn con-

trol(s) to off, and turn off power to 

heater circuit at main disconnect 

panel.

7.  Do not insert or allow foreign 

objects to enter any ventilation 

or exhaust opening as this may 

cause an electric shock or fire, or 

damage the heater.

8. 

To prevent a possible fire, do not 

block air intakes or exhaust in any 

manner.

9.  A heater has hot and arcing or 

sparking parts inside. Do not use 

it in areas where gasoline, paint, 

or  flammable  vapors  or  liquids 

are used or stored.

10. Use this heater only as described 

in this manual. Any other use 

not recommended by the manu-

facturer  may  cause  fire,  electric 

shock, or injury to persons.

11. CAUTION – High temperature, 

risk of fire, keep electrical cords, 

drapery, furnishings, and other 

combustibles at least 3 feet (0.9 

m) from the front of the heater 

and away from the side.

  

When using electrical appliances, basic precautions should always be 

followed  to  reduce  the  risk  of  fire,  electric  shock,  and  injury  to  persons, 

including the following:

Tape Measure

Straight and Phillips 

Screwdrivers

1½" Wood Screws

Wire Strippers

Wire Connectors

½" Cable Clamp 

Connector

Volt Meter

Drill and Drill Bits

Stud Finder

A multi-purpose tool or something to cut your existing drywall or gypsum board.

®

®

®

®

®

®

Hammer

®

®

®

®

Содержание RM168









Отзывы: