INSTALLATION INSTRUCTIONS
3
1.
All electrical work and materials
must comply with the National Elec
-
tric Code (NEC), the Occupational
Safety and Health Act (OSHA), and
all state and local codes.
2.
Use copper conductors only.
3. Use only on series F baseboard
heaters.
4.
Turn off power to heater at main
disconnect panel.
5. Connect grounding lead to grounding
screw provided on the heater.
6. Use wire connectors (not included)
for all connections.
•
Verify power has been turned off before starting any work!
• Follow the instructions in your Baseboard Owner’s Guide (included with your heater) until
prompted to make thermostat connections.
• IMPORTANT:
If wiring on the left side, cut
ONLY ONE
factory connection and
ONLY
on the
side you will be wiring! If your baseboard is a 120 volt model, cut ONLY the factory connec
-
tion that has one black and one white wire!
240/208
Volt
LEFT SIDE
TIPS BEFORE YOU BEGIN
A.
Connect one supply wire to
the red thermostat wire.
B.
Connect the black
thermostat wire to one of the
heater wires.
C.
Connect the remaining
supply wire to the remaining
heater wire.
Wrap supply (white) wire with
black tape to identify it as hot!
Tuck all the wires back into
the individual wiring compart
-
ments, and make sure the
connections are tight. Attach
with small screw at bottom.
SINGLE POLE (2-WIRE) BTF1 - 240/208 or 208 VOLT
240/208
Volt
RIGHT SIDE
PARTS OF YOUR THERMOSTAT
control knob
top
bottom
Proceed to OPERATING INSTRUCTIONS.
A
B
C
A
B
C
DO NOT
CUT!
