Cadence United Boston, Руководство пользователя

Страница: 6 / 15

10 11
Install any combination of speakers independently on all 4 channels being careful not
to load any single channel below 2 ohm stereo. For typical 6” x 9” or 6.5” or component
speaker installs, set the Crossover Mode Switch to Full Range.
When bridging the four channel amplifier, make sure that your final woofer impedance on each bridged
channel is no lower than 4 ohms. Set the Crossover Mode Switch to Low Pass and begin by setting the
crossover frequency control to 100Hz and tuning from there. The dashboard bass remote control works only
on channels set to Low Pass.
Basic 4 Channel Configuration 4 Channel Amplifier Bridged to 2 Channels
CROSSOVER MODES SWITCH IN
FULL RANGE POSITION
LEFT SPEAKER
2-4 OHM
RIGHT SPEAKER
2-4 OHM
LEFT SPEAKER
2-4 OHM
RIGHT SPEAKER
2-4 OHM
CH 1-2
CROSSOVER MODE SWITCH
IN LOW PASS POSITION
CH 3-4
CROSSOVER MODE SWITCH
IN LOW PASS POSITION
RIGHT SUBWOOFER
MINIMUM IMPEDANCE
4 OHMS
LEFT SUBWOOFER
MINIMUM IMPEDANCE
4 OHMS
FRONT SPEAKERS
REMOTE SUBWOOFER
LEVEL CONTROL
REAR SPEAKERS