4 CHANNEL AMPLIFIER IN 3 CHANNEL MODE
16
SUBWOOFER
MINIMUM IMPEDANCE
4 OHMS
REMOTE SUBWOOFER
LEVEL CONTROL
CH 1-2
CROSSOVER MODE SWITCH
IN
HIGH PASS
POSITION
CH 3-4
CROSSOVER MODE SWITCH
IN
LOW PASS
POSITION
LEFT
SPEAKER
2-4 OHMS
RIGHT
SPEAKER
2-4 OHMS
CHANNEL 3-4 CONTROL ONLY
Channels 1 and 2 should be wired
to speakers no lower than 2 ohm
loads per channel in stereo. Channel
3 and 4 should be bridged as per the
diagram wiring the woofer to Channel
3 positive side (+) and Channel
4 negative side ( – ) terminals.
Set the crossover mode switch
of Channels 1 and 2 to either Full
Range or High Pass, while Channels
3 and 4 should be set to Low Pass.
Remember that the Dashboard
Bass Remote Control works only on
Low Pass Channels.
Please see page 13 for RCA input
configuration details and instructions
when wiring a 3 channel system.
Содержание Flash F100-5
Страница 1: ......
