CADDX Ranger 9000E, Руководство пользователя

Страница: 6 / 10

KEYPAD CONTROL TONES (BEEPS)
A sounder is built into the keypad control and may sound for one of the following reasons:
Beeps for all keypresses.
Beeps continuously during the Entry delay time.
Pulses when a day zone is violated and the system is disarmed, a FIRE zone has a trouble
condition, or when the armed status changes and the AC power is off, or a
FIRE/TROUBLE condition exists. When pulsing, it may be silenced by entering a valid
code. The Armed state of your security system will not change when you enter a code to
silence a pulsing sounder.
Pulses when a phone line fault is detected.
3 beeps for trying to arm with the “READY” light off.
Beeps 1 second for the “CHIME” feature.
Beeps 1 second at the end of the exit delay.
AUDIBLE ALARM SOUNDS
FIRE: Steady Siren (Beeping Keypad)
INTRUSION PANIC: Yelp siren
RESETTING YOUR SECURITY CONTROL CENTER
In the event of a system malfunction in the Security Control Center, press the [#] (reset) key
on the keypad control. This should reset the code sequence and restore normal operation. If
the problem persists, call the service number located on page 1 of this booklet for service.
ALARM MEMORY
To obtain the last alarm information, press and wait 5 seconds. All zones violated
during last alarm will flash. All zones that bypassed during the last alarm will be a steady light.
QUICK-ARM FEA TURE
If checked, your security system has a “QUICK ARM” code programmed. This feature will
allow you to arm the security system by pressing one, pre-designated key on the keypad
control. This “QUICK ARM” code is for
ARMING ONLY, and will not disarm the security
system. This makes it ideal for a maid code, babysitter code, etc. This code can only be
programmed and/or changed by your installing company.
AUTOMATIC BYPASS OPTION
If checked, your installing company has selected the “AUTOMATIC BYPASS” option. With this
feature enabled, all interior zones will automatically bypass if you “ARM” your security system
and do not leave through a designated entry/exit door. The “AUTOMATIC BYPASS” will occur
at the end of the exit delay time. At this time, all bypassed “ZONE” lights will become
illuminated. With the interior zones bypassed, occupants are allowed the freedom of
movement inside of the Home/Business white the security system is “ARMED”.
q
GROUP BYPASS OPTION
If checked, your installing company has selected the “GROUP option. If you wish
to bypass all zones designated as “GROUP BYPASS” zones, you may do so by pressing the
key during the exit delay. Once these zones have been bypassed, they will remain
bypassed until the system is disarmed Once “GROUP BYPASS” zones been bypassed