CM-SR644024_09-11-2023_Rev-25
Page. 6
General Precautions
•
Do not place heavy objects on the stage rack, expose it to sharp objects or handle the stage
rack in any way that may cause damage, e.g., rough handling and /or excessive vibration.
•
Do not subject the equipment to dirt, dust, heat or vibration during operation or storage. Never
expose the stage rack to rain or moisture in any form. Should the stage rack become wet, turn
it off and disconnect it from the mains without further delay. The stage rack should be given
sufficient time to dry out before recommencing operation.
•
When cleaning the stage rack, never use chemicals, abrasive substances or solvents.
•
The stage rack control screen should be cleaned using a soft brush and a dry lint-free cloth. For
persistent marks, use a soft cloth and isopropyl alcohol. Switches and potentiometers do NOT
require cleaning or lubrication.
•
Keep these instructions for future reference. Follow all warnings in this manual and those
printed on the console.
•
The stage rack must be connected following the guidance in this manual. Never connect power
amplifier outputs directly to the stage rack. Connectors and plugs must never be used for any
other purpose than that for which they are intended.
•
The stage rack mains input must always be connected to correctly rated mains power as
referred to in this manual. The mains input must, at all times, be connected to the local mains
power supply using the supplied power cord. In cases where the supplied plug does not fit, a
qualified electrician must be consulted.
•
The power cord must be routed in such a way that the risks of accidentally stepping on it,
stretching it or it being pinched are minimized.
•
WARNING! THIS EQUIPMENT MUST BE EARTHED!
•
Ventilation slots must never be covered or obstructed in any way, otherwise airflow required for
safe operation may be restricted. Where the stage rack is to be operated in a flight-case, then
this must be located in such a way that it allows for proper ventilation.
•
Refer servicing to qualified technical personnel only.