8. Assembly
•
Begin by unpacking and laying out all of the components of the barbecue and ensuring that all of the items listed in Section 7
are there.
•
Read the assembly instructions in full before starting assembly.
Ÿ
PLEASE NOTE!
Images may vary depending on the model you purchased
8.1 Getting Started
8.3.1 Steps to Assembling the Legs
•
Star screw driver.
•
Size 10 spanner.
8.2 Tools Needed For Assembly
Ÿ
Place the fire bowl on the ground with the inner leg brackets facing up.
Ÿ
Push the M10 bolt through the bottom of the leg. Fit the wheel over the bolt from the other side, and fasten them together
with the M10 nut. Fit the wheel cover into place (See step 2)
Ÿ
Fit the outer leg bracket over the open end of the leg.
Ÿ
Assemble the legs by sliding the open end of the leg over the leg inner bracket. Push the leg completely down, until the
hole in the leg aligns with the threaded insert in the leg bracket. Fasten the leg to the fire bowl using the M6 x 16mm
screw and washer supplied.
Please note that the legs must be securely fastened so that the BBQ unit is stable when in use.
Step 1
Step 3
Inner Leg Brackets
Fire Bowl
Step 2
M10 Bolt
M10 Nut
Wheel Cap
Wheel
Leg
M10 Washer
Outer Leg Brackets
M6 x 16 screws
M6 washers
Do not tighten the M6 screws too tight to allow
for easy installation of the wire tray.
