Cactus V4, Руководство пользователя, Страница: 5 / 12

OPERATION
5
Batteries
Install two (2) AAA size 1.5V batteries (IEC: R03) into the receiver and one (1)
L1028 23A 12V battery into the transmitter. Alkaline batteries are
recommended. Rechargeable batteries also work but operation time may
be reduced.
When LED on the receiver or transmitter stops blinking, it is time to change
batteries. Battery life of receiver is approximately 10,000 flashes under
typical use while battery life of transmitter is approximately 20,000 triggers.
Operation
CAUTION
Turn OFF your equipments (Cactus units, flash units and cameras, etc.)
before changing batteries or making connection. Observe the correct
polarity when changing batteries. There is danger of explosion if battery is
installed incorrectly.
Never touch the PCB board or any electronic components when changing
batteries in the transmitter.
Remove batteries and switch off the receiver during storage.
Do not remove battery covers during operation.
Do not operate the device in the presence of flammable gases or fumes.
!
1.
2.
3.
4.
5.
For portable external flash
Connect the hot shoe of the external flash to that of the receiver, or
connect the receiver to the flash’s PC sync port by using PC Sync cable
(CA-100).
For studio strobes
Connect the receiver to your studio strobe by using 3.5mm plug cable
(CA-350) or 6.35mm plug cable (CA-635) according to port size of your
strobe.
Switch on the power of the receiver.
Set the channel of the receiver according to the table in page 6 so that
it is the same as that of the transmitter. The switch of the receiver
locates next to the hot shoe connection. 1.
2.
3.