3
2018 DOUBLE AGENT USER MANUAL
FOIL ACCESSORY INVENTORY LIST
(1x) Top Plate – mast / board connection
(1x) Foil Mast – Sizes: 85cm; 60cm, 40cm
(1x) Foil Fuselage – Size: 60cm
(2x) Foil wings (Front & Rear Wing)
(4x) M8x40 Titanium 5mm Hex bolts
(2x are already installed in the Top Plate / Mast)
(8x) M8x25 Titanium 5mm Hex bolts
(1x) 5mm Hex key
MOUNTING THE TOP PLATE/MAST TO THE BOARD
1. Open the Foil pack.
2. Remove the Hardward located in the ziplock back: 2x M8x40
Titanium 5mm Hex bolts; 8x M8x25 Titanium 5mm Hex bolts; 5mm
hex key.
3. Remove the Top Plate/Mast – these 2 components come already
assembled with 2x M8x40 Ti Hex Bolts.
4. Placing the Double Agent Board on it’s side insert 2x M8x25 Ti Hex
Bolts down from the top of the board on opposite sides (FIG. 1).
5. Orientate the Top Plate/Mast so that the leading edge of the mast
(thicker section along the mast) is faccing forward towards the nose
of the board (FIG. 2).
6. Using the 5mm Hex key lightly tighten the 2x M8x25 Ti Hex Bolts
from the top of the board into the corresponding holes on the top of
the Mast (FIG. 3).
7. Insert the remaining 2x M8x25 Ti Hex Bolts down through the top
of the board and lightly tighten into the mast.
8. Once all bolts are located, one by one tighten each bolt until hand
tight. Be careful not to cross the threads. If resistance is found, stop
tightening and reverse the direction of rotation and try again.
CAUTION: DO NOT OVER TIGHTEN THE BOLTS AS THIS WILL
DAMAGE THE BOARD OR THE FOIL.
ASSEMBLING THE FUSELAGE & MOUNTING FOIL WINGS TO
THE FUSELAGE
1. Turn the Double Agent board with the mounted Top Plate/Mast
upside down so that it is laying on it’s deck with the shaft in the air.
2. Remove the Fuselage from the packing foam & identify the
orientation of the fuselage. The mast placement on the fuselage is
offset forward, when mounted the shorter section of the fuselage
should be facing forward (FIG. 4).
3. Loacte the grove on the fuselage that matchs with the profile of
the mast. Seat the fuselage on the mast & make sure that they are
seated correctly (FIG. 5).
9. Take 2x M8x40 Ti Hex Bolts, use the 5mm hex key to thread each
through the fuselage into the mast then tighten each bolt until the
fuselage is secure. If resistance is found, stop tightening and reverse
the direction of rotation and try again (FIG. 6).
CAUTION: DO NOT OVER TIGHTEN THE BOLTS AS THIS WILL
DAMAGE THE FOIL.
DOUBLE AGENT FOIL INSTALATION
FIG 1
FIG 2
FIG 3
FIG 4
FIG 5
FIG 6
Содержание 2018 DOUBLE AGENT
Страница 1: ...2018 DOUBLE AGENT USER MANUAL ENGLISH...