6C110 Power Bridge Adapter Installation Instructions
9033011
Page 5 of 7
6. Connect the rear (black) power bridge adapter connectors to the lower backplane connectors of the chassis.
Ensure that the connectors are firmly seated together, and the screw holes of the power bridge adapter align with
the standoffs installed in step 4 and the support clip installed in step 5. See Figure 5.
Figure 5 Installing the Power Bridge Adapter
7. Attach the power bridge adapter to the lower backplane by fastening the three screws to the standoffs installed
in step 4 and one screw to the support lip installed in step 5. See Figure 5.
Installation is complete.
Installing the Blank Faceplate
If the 6C110 chassis will be equipped with a single power supply only, the blank faceplate included with the
upgrade kit must be installed in the slot labeled “PS2”.
To install the blank faceplate, refer to Figure 6 and proceed as follows:
NOTE
The following instructions should be performed only when a single power supply is
installed in the 6C110 chassis.
!
CAUTION
If the 6C110 is configured with a single power supply module, it
must
be located in slot PS1.
6C405
Lower Backplane
Connectors (2)
Standoff
Standoffs (2)
Screw Holes (2)
Screw Holes (2)
Power Bridge
Adapter
Support Clip
