Cabletron Systems MMAC-Plus 9H421-12, Руководство пользователя

Страница: 17 / 38

2-1
Chapter 2
Installing the SmartSwitch 9000
Module
The 9H421-12, 9H422-12 and the 9H429-12 modules each occupy a single slot in
the SmartSwitch 9000 chassis.
Install any of these modules by following the steps starting below.
Unpacking the Module
1. Carefully remove the module from the shipping box. (Save the box and
packing materials in the event the module must be reshipped.)
2. Remove the module from the static bag. Observe all precautions to prevent
damage from Electrostatic Discharge (ESD).
3. Carefully examine the module, checking for damage. If any damage exists,
DO NOT install the module. Contact Cabletron Systems Technical Support
immediately.
Installing an FEPIM
The 9H422-12 provides a slot for a Cabletron FEPIM (Fast Ethernet Port Interface
Module). The 9H422-12 SmartSwitch module is shipped without an FEPIM. To
install an FEPIM, follow the procedure below:
1. Remove the module if it is installed in the SmartSwitch 9000 chassis.
2. Remove the two screws securing the plate on the side of the FEPIM slot.
3. Install the FEPIM as shown in Figure 2-1. Ensure that the rear connector is
seated firmly before tightening the three mounting screws.
4. Replace the plate and two screws on the side of the FEPIM slot.