Cabletron Systems MMAC-M3FNB, Обзор и руководство по установке

Страница: 21 / 28

MMAC-M3FNB SETUP
Page 3-1
CHAPTER 3
MMAC-M3FNB SETUP
This chapter contains instructions to help you set up Cabletron
Systems’ MMAC-M3FNB. You will not need any special tools or
equipment to set up the MMAC-M3FNB, but you must follow all
guidelines listed in Chapter 2, Installation Requirements and
Specifications.
3.1 UNPACKING THE MMAC-M3FNB
Before you install the MMAC-M3FNB, you should inspect the unit.
To unpack the MMAC-M3FNB:
1. Remove the MMAC-M3FNB and fan tray from the shipping box.
Save the shipping box and materials in the event the
MMAC-M3FNB has to be reshipped.
2. Slide the two foam end caps off the MMAC-M3FNB, and remove
the unit from the protective plastic bag. Set the MMAC-M3FNB
aside in a safe place.
3. Remove the accessory package and verify that it contains two
mounting brackets, a cable tie tray, and a small plastic bag with
screws (two #10 screws, 3/8” long).
Contact Cabletron Systems Technical Support immediately if any
discrepancy exists.
3.2 SETTING UP THE MMAC-M3FNB
The following sections list the steps necessary to set up your
MMAC-M3FNB, including installing the MMAC-M3FNB in the
desired location, inserting the fan tray, and inserting the power supply
module.